11/12/2022 0 Comments Cleanflight arm with spin![]() ![]() ![]() It is possible to use both types at the same time, which may be desirable. The idea is that the flight controller starts using fallback settings for all controls, which are set by you, using the CLI command rxfail (see rxfail section in rx documentation) or the cleanflight-configurator GUI. See your receiver's documentation for this method.įlight controller based failsafe is where the flight controller attempts to detect signal loss and/or the failsafe mode of your receiver and upon detection goes to failsafe stage 1. The idea is that you set throttle and other controls so the aircraft descends in a controlled manner. Receiver based failsafe is where you, from your transmitter and receiver, configure channels to output desired signals if your receiver detects signal loss and goes to the failsafe mode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |